Search for: All records

Abstract. Secondary inorganic aerosols (sulfate, nitrate, and ammonium, SNA) are major contributors to fine particulate matter. Predicting concentrations of these species is complicated by the cascade of processes that control their abundance, including emissions, chemistry, thermodynamic partitioning, and removal. In this study, we use 11 flight campaigns to evaluate the GEOS-Chem model performance for SNA. Across all the campaigns, the model performance is best for sulfate (R2 = 0.51; normalized mean bias (NMB) = 0.11) and worst for nitrate (R2=0.22; NMB = 1.76), indicating substantive model deficiencies in the nitrate simulation. Thermodynamic partitioning reproduces the total particulate nitrate well (R2=0.79; NMB = 0.09), but actual partitioning (i.e., ε(NO3-)= NO3- / TNO3) is challenging to assess given the limited sets of full gas- and particle-phase observations needed for ISORROPIA II. In particular, ammonia observations are not often included in aircraft campaigns, and more routine measurements would help constrain sources of SNA model bias. Model performance is sensitive to changes in emissions and dry and wet deposition, with modest improvements associated with the inclusion of different chemical loss and production pathways (i.e., acid uptake on dust, N2O5 uptake, and NO3- photolysis). However, these sensitivity tests show only modest reduction in the nitrate bias, with no improvement to the model skill (i.e., R2), implying that more work is needed to improve the description of loss and production of nitrate and SNA as a whole. 

Abstract. Airborne and ground-based measurements of aerosol concentrations, chemicalcomposition, and gas-phase precursors were obtained in three valleys innorthern Utah (USA). The measurements were part of the Utah Winter FineParticulate Study (UWFPS) that took place in January–February 2017. Totalaerosol mass concentrations of PM₁ were measured from a Twin Otteraircraft, with an aerosol mass spectrometer (AMS). PM₁ concentrationsranged from less than 2µgm⁻³ during clean periods to over100µgm⁻³ during the most polluted episodes, consistent withPM_2.5 total mass concentrations measured concurrently at groundsites. Across the entire region, increases in total aerosol mass above∼2µgm⁻³ were associated with increases in theammonium nitrate mass fraction, clearly indicating that the highest aerosolmass loadings in the region were predominantly attributable to an increase inammonium nitrate. The chemical composition was regionally homogenous fortotal aerosol mass concentrations above 17.5µgm⁻³, with 74±5% (average±standard deviation) ammonium nitrate, 18±3%organic material, 6±3% ammonium sulfate, and 2±2%ammonium chloride. Vertical profiles of aerosol mass and volume in the regionshowed variable concentrations with height in the polluted boundary layer.Higher average mass concentrations were observed within the first few hundredmeters above ground level in all three valleys during pollution episodes. Gas-phase measurements of nitric acid (HNO₃) and ammonia (NH₃) duringthe pollution episodes revealed that in the Cache and Utah valleys, partitioningof inorganic semi-volatiles to the aerosol phase was usually limited by theamount of gas-phase nitric acid, with NH₃ being in excess. The inorganicspecies were compared with the ISORROPIA thermodynamic model. Total inorganicaerosol mass concentrations were calculated for various decreases in totalnitrate and total ammonium. For pollution episodes, our simulations of a50% decrease in total nitrate lead to a 46±3% decrease in totalPM₁ mass. A simulated 50% decrease in total ammonium leads to a36±17%µgm⁻³ decrease in total PM₁ mass, over the entirearea of the study. Despite some differences among locations, ourresults showed a higher sensitivity to decreasing nitric acid concentrationsand the importance of ammonia at the lowest total nitrate conditions. In theSalt Lake Valley, both HNO₃ and NH₃ concentrations controlledaerosol formation. 

We use a 0-D photochemical box model and a 3-D global chemistry-climate model, combined with observations from the NOAA Southeast Nexus (SENEX) aircraft campaign, to understand the sources and sinks of glyoxal over the Southeast United States. Box model simulations suggest a large difference in glyoxal production among three isoprene oxidation mechanisms (AM3ST, AM3B, and MCM v3.3.1). These mechanisms are then implemented into a 3-D global chemistry-climate model. Comparison with field observations shows that the average vertical profile of glyoxal is best reproduced by AM3ST with an effective reactive uptake coefficient γglyx of 2 × 10-3, and AM3B without heterogeneous loss of glyoxal. The two mechanisms lead to 0-0.8 µg m-3 secondary organic aerosol (SOA) from glyoxal in the boundary layer of the Southeast U.S. in summer. We consider this to be the lower limit for the contribution of glyoxal to SOA, as other sources of glyoxal other than isoprene are not included in our model. In addition, we find that AM3B shows better agreement on both formaldehyde and the correlation between glyoxal and formaldehyde (RGF = [GLYX]/[HCHO]), resulting from the suppression of δ-isoprene peroxy radicals (δ-ISOPO2). We also find that MCM v3.3.1 may underestimate glyoxal production from isoprene oxidation, in part due to an underestimated yield from the reaction of IEPOX peroxy radicals (IEPOXOO) with HO2. Our work highlights that the gas-phase production of glyoxal represents a large uncertainty in quantifying its contribution to SOA.